A clean visor is a safety item as much as a comfort one, since scratches and haze scatter light and make it harder to judge distance in low sun or at night. Clean a visor with lukewarm water and a soft cloth, and avoid dry wiping, which is what causes most fine scratches in the first place.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.

To see the current range built this way, visit Hedonist.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

Getting helmet sizing right starts with a proper head measurement, taken with a soft tape around the largest part of the head, just above the eyebrows and ears. That figure points to a starting size, but it is only a starting point, since head shape varies as much as head size.

This kind of workshop sits closer to a design studio than a factory. Colourways, trims and finishes are developed the way a small run of any crafted object would be, with samples, adjustments and a final sign off before anything reaches a rider.